Harmar Mobility AL500 User Manual download pdf (Page 11)

DO NOT

With platform on the ground, drive scooter onto platform, from left (driver's side ) to right, until the rear

wheels are located in the rear wheel spreader bar assembly. Stop when the rear tires contact the ramp

on the platform.

Raise the platform on either lift until the motor's clutch

is heard ( top of travel ). Loosen both nuts on hold down arm, and thread the Hold Down Foot down to

the scooter's deck. Lower Platform about 1-2 inches. Thread Hold Down Foot down once again to

scooter's deck. Raise Platform. Verify Hold Down Foot places adequate pressure on scooter.

adjust the leg so far down that the top of the threaded rod does not protrude through the top

of the pivot tube. Once the foot is adjusted to the proper position, tighten the jam nut to lock it in place.

Once the lift is properly adjusted, lower the platform to the ground and raise it back to the

transporting position. Repeat this several times to make sure all parts are operating properly and

that the scooter is properly secured. Next, remove the scooter from the lift and using the toggle

switch, cycle the lift completely up and down to make sure that all parts are in working order and the

lift fol ds up when it is empty.

Caution: On some scooters, it may be necessa ry to temporarily move the steering tiller forward to

clear the hold down arm as it lowers into the lock down position.

Caution: Some scooters have pneumatic (air inflated) tires. If your scooter has this type tire, be

sure the tires are properly inflated. Improper inflation of the tires will change the deck height of the

scooter and therefore change the amount of clamping force the hold down arm places on the

scooter. The scooter can fall off of the lift if not properly secured.

Caution: Be sure to instruct the end user not to enter steep driveways straight on. Enter and leave

at an angle to the street so that your lift platform does not drag on the ground.

NOTE: Drive the scooter off in REVERSE. When the scooter is clear of the platform, raise t

platform by pushing up on the UP/DOWN switch.

NUT

END OF THREADED ROD

MUST PROTRUDE

THROUGH TOP OF

TUBE AND NUT

AL100

SETTING HOLD DOWN FOOT HEIGHT

Loosen top nut

and bottom nut

Turn threaded rod

to lengthen or

shorten foot

LIFT PREPARATION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

No comments

Harmar Mobility AL500 User Manual Page 11